In feb 2008 I bought a Cat interface for my FT1000D , I’ve found out that I needed firmware version V6 for the control with modern technic software. At work I burned a few new Eeprom’s with the latest V6 firmware from Yaesu. Here you will see how to replace the old one with the new firmware.. After it is installed put the power cord back in for the latest test. Push the 1,.5 and 7 Mhz band switch en power up. The Yaesu will reset en shows the firmware version you have installed. If you need more info just send me an email msg.

voorkant-eeprom eeprom 5.84 eeprom v6 installed eeprom v6

Here the changes I’ve made. The FT1000D I upgraded the standard Yaesu Filter for total Inrad Filters. You see before and after. Two of the filters I had to solder out from the board . I needed a very warm heatpipe to do the job. It was hard to do, but we managed it. Just be careful with the old print board, don’t damage anything of the print with the warm heatpipe. It’s been done easy and your Yaesu won’t work anymore. After all these years Yaesu have been making great radio’s.

IMG_1059 IMG_1062 IMG_0043 IMG_0045

Inrad filter setup in the Yaesu FT-1000D

455 kHz IF-filters

Inrad #715-C 2800 Hz instead of the Yaesu XF-2600 HZ

Inrad #702-C 2100 Hz instead of the Yaesu XF-D 2000 Hz

Inrad #721-C 500 Hz instead of the Yaesu XF-E 500 Hz

Inrad #704-C 250 Hz instead of the Yaesu XF-F 250 Hz

8.2 MHz IF-filters

Inrad #716-B 2800 Hz instead of the Yaesu XF-8.2M-262-01

Inrad #709-B 2100 Hz instead of the Yaesu XF-8.2M-202-01

Inrad #701-B 400 Hz instead of the Yaesu XF-8.2M-501-03

Inrad #708-B 250 Hz instead of the Yaesu XF-8.2M-251-01